B
Esential tuner for beginner eurorack
I was debating shelling out for the Mordax DATA but there is nothing this little guy doesnt do for half the foot print that id use the DATA for.
1
0
Report
m
Excellent easy to use scope
Very easy to use scope, controls are intuitive and integration within patches makes it easy. The V range is nice, I have a full-size scope near the rack that cost four times as much and most of the time end up just using this scope since it is designed _for_ eurorack voltages. Size is a benefit for smaller setups, but does come with the compromise of the smaller screen, but that should be expected. My only issue was the top M3 screws have a longer thread and thus cannot be replaced with knurlies and thus is the one module that requires a screwdriver. However, if installed in the right place (as it is in my setup) one should not need to worry about this after install.
0
0
Report
x
Nice 2 channel oscilloscope
Only downside is, that the display is rather small, but then it fits in 6HP.
I can highly recommend having an oscilloscope in your modular rack, especially for looking at complex control voltages, for example a mix of LFOs.
I can highly recommend having an oscilloscope in your modular rack, especially for looking at complex control voltages, for example a mix of LFOs.
0
0
Report
BS
Works Great
No problems with this module, the ZeroScope is easy to use.
0
0
Report
TR
The most useful device in my rack
Being able to see the wave for a signal chain is invaluable. It makes it easier to understand what other modules are actually doing. The unit has two inputs that lets you monitor two signal chains.
0
0
Report