A
Can't imagine using my Rockboard without it
Been using it in my Rockboard 4.2 for over 2 years now. I have a BOSS RC-600 looper on my board along with 11 other pedals, and it makes everything very convenient and tidy. No added noises to the system, no complaints about build quality. Bought an XLR reverser adapter cable so I can connect 2 mics to it, two of the 1/4" outputs are routed as L & R mono outputs from RC-600, and the third jack output is for Stereo Headphone Out, very convenient. 3x 1/4" TRS outputs can be turned into 6x mono in-outs using Y-splitter cables, which is great versatility. The added 9V output great for powering any extra pedals that are not permanently on my board that I might be using or trying out. It saves a lot of time and mess - no fiddling about with cabling, going under the board to connect or route something - just plug what you need in the MOD 3 patch-bay, connect the power cable, and everything works.
0
0
Report
LR
I love it!
Makes my board a lot neater and it looks cool too! Perfect for singer/guitarists (like me) or anyone that needs a few xlr ports on top of the normal jacks.
1
0
Report
CM
Extremely useful passive connections
Needed this for a pedalboard build a few years back and have used it in a few different routing / signal chains since then.
The other rockboard patchbays look great too but this has the perfect connections for me. The Jack's being TRS for stereo or midi control is great. Makes routing a board with midi controls/foot controller so much neater and easier.
It is also nice for putting my amp foot switch, guitar signal and vocal mic outputs all within a few centimetres. Max setting up at the gig feel like no work at all.
The other rockboard patchbays look great too but this has the perfect connections for me. The Jack's being TRS for stereo or midi control is great. Makes routing a board with midi controls/foot controller so much neater and easier.
It is also nice for putting my amp foot switch, guitar signal and vocal mic outputs all within a few centimetres. Max setting up at the gig feel like no work at all.
1
1
Report
J
LOVE IT!!!
ease of use and makes my board clean. using it for my rockboard quad 4.2. Thanks thomann!
0
0
Report
CF
Great!
It’s a lovely bit of gear and everything is strong and nicely put together. Jacks may be a bit close for some larger 1/4” plugs but. I’ve not found any yet that don’t fit side by side so, maybe I’m wrong
0
0
Report
RO
Best RB Mod for guitarist and vocal pedalboard
Easy to install. I used this mod on my RB Cinque 5.2. Since I also sing I have my VE-500 hooked up to the XLR in and outs. To the other review that says xlr cables do not fit in the rockboard pedalboard.... Of course! Buy the rockboard flat XLR cables. That would fit between the RB pedalboard holes.
I use the DC pass through to plug in my QC powerbrick.
I only wish this also had the USB passthrough.
I use the DC pass through to plug in my QC powerbrick.
I only wish this also had the USB passthrough.
0
0
Report