CM
Great sound, pity!
These jacks are of high quality materials and construction, and have a positive impact on the sound of a cable.
However, there are some drawbacks.They are awkward to solder, because of the cramped positioning of the lugs. And stiff when fitting to the cable. I wasn't able to fully tighten the screw cap on a couple of my cables (6.8mm diameter).
There are good instructions on Neutrik's website.
However, there are some drawbacks.They are awkward to solder, because of the cramped positioning of the lugs. And stiff when fitting to the cable. I wasn't able to fully tighten the screw cap on a couple of my cables (6.8mm diameter).
There are good instructions on Neutrik's website.
0
0
Report
A
When I decided to solder my own cables the Neutrik NP2 RX-B was one of my "weapons of choice" for the job. It is a high quality built plug. It is not so easy to solder it on the cable despite the detailed instruction on Neutrik's Website. The spot where you must solder the hot wire of the cable is a bit narrow. But with a bit of practice even I, as a complete newbie in soldering, could make it.
The strain relief works perfect even on thicker cables (I used it in connection with a Sommer "The Spirit" cable, which has a diameter of about 7mm.
The strain relief works perfect even on thicker cables (I used it in connection with a Sommer "The Spirit" cable, which has a diameter of about 7mm.
0
0
Report
