D
Great for my behringer FCB1010
I got this for my behringer FCB1010 and it fits nicely. It even has a little bit of space around the footboard for me to put a power extension in. It also has some extra height room so I can put pedals and power cables in there too. Its great for moving my board around and adds a good level of protection, but I don't think it would hold up that well under a big impact. I guess that's why it's on the cheaper side of things. Overall I am very happy with the case and for the price, the quality is good.
0
0
Report
JD
Handy bag, fairly good quality and inexpensive.
Bought it to fit the Behringer FCB - which it does, but not quite as snugly as it might. You can't use the board in the bag - just in case you were wondering, but that's ok. Recommended if needed to transport your gear around in a safe and secure manner.
0
0
Report
A
Really nice case
I bought this a few weeks after buying the Behringer footswitch because it was too long to fit in my previous case. This is really nicely made for a soft case, lots of padding, and the footswitch fits into it perfectly. There is also an outer zip up compartment which I can fit several leads (jack, midi, power, etc). My only criticism is that the inside space is a touch too deep so the switch can rock back and forwards slightly. This would never cause a problem because the inside is nicely padded, but I may tape in a small piece of foam to stop it moving. Not a problem, just something you might want to change. Overall a great case for the money.
0
0
Report
F
Good size, Carry Strap broke after a couple of uses
Used for my full Boss GT-1000 pedal, really good fit, but sadly the shoulder strap broke (stitching gave way). Maybe I had too much weight in it, but works very well with the normal handles as well.
0
0
Report
Ra
Better protection than a soft bag.
I bought this for the old Line6 floorboard and fits very well. Good quality.
0
0
Report
A
this one saved me
i was looking for a bag or case for my Korg M3-m modul,and i found on some forum that SKB SC2709 can be solution for me,but it had to be changed in some way(some cutting for knobs). but it fits pefectly inside! very satisfied
0
0
Report
A
Good value!
I bought this case for my Behringer FCB1010 and it fits in perfectly.
Used it few times a week for over a month now and it's holding up without any damage. The case is padded and quite durable, I don't worry about throwing it in on top of other equipment in the van for long drives. It also fits my Kurzweil sustain pedal inside the main compartment and a couple of long leads in the additional front pocket.
Used it few times a week for over a month now and it's holding up without any damage. The case is padded and quite durable, I don't worry about throwing it in on top of other equipment in the van for long drives. It also fits my Kurzweil sustain pedal inside the main compartment and a couple of long leads in the additional front pocket.
0
0
Report
EW
Decent semi hard case/bag
Bought it to store the FCB1010 foot controller. Works fine and not too heavy, though the fabric interior does cling on to debris or dust easily.
0
0
Report
R
Perfect fit
This case is a perfect fit for the Behringer FCB1010 midi pedal board with space in the outside pocket for a mains lead and midi cables. Plenty of foam padding means the board should be well protected. The usual excellent service from Thomann.
0
0
Report
F
Frank Atwater
A good bag , sturdy , light weight , so far no problems , have had 1.5 years
0
0
Report
