F
Great idea, but didn't work for me
I had this on my board between two Mad Professor pedals to save space on the board, and it worked fine for a while. After that I started getting scratchy noises when hitting the two pedals that were joint by this. I replaced it with a cable, and the noise went away. My guess is that the pedals moved sligtly on the pedal board, so they were not perfectly aligned anymore. But if you could align the pedals and make sure they moved as much as a mm, then it would probably work fine.
0
0
Report
n
too good to be true. Good quality though!
the jacks in/out from the pedals are often not aligned when they rest on a flat surface. so beware!
0
0
Report
N
Small and clean!
These connectors from Rockboard are really nice. They are small and strong. I really recomend if you are searching for something clean and small.
Pay attention with your power supply connection because for some pedals it just doenst fit.
Pay attention with your power supply connection because for some pedals it just doenst fit.
0
0
Report
r
Rockboard Z-Connector nickel
These connectors are strong, well made and take up very space, ideal for a crowded pedal board. The offset design allows pedals of different makes to be connected, for example I connected a Boss pedal to an Ibanez. I also used Rockboard N and S connectors with similar results.
0
0
Report
S
Perfect for a small pedalboard
This connector is just perfect for fit your pedals.
Very useful when you need to save space between pedals.
Its not the cheapest one but it works great!
Very useful when you need to save space between pedals.
Its not the cheapest one but it works great!
0
0
Report
FF
Good proeduct, bad use
The ideia of those conector is really good, but it is bad for the jacks of your pedals. The best way possible to connect them is by patch cables.
It is just a bad ideia to connect to jacks with no flexibility between them.
It is just a bad ideia to connect to jacks with no flexibility between them.
0
0
Report