B
A time saver.
Having built numerous XLR patch bays, I would recommend anyone building one with the Neutrik feed-through connectors to buy some of these, as they are by far the easiest way to secure the connectors to the panel. They save a lot of time and frustration by not having to use fiddly nuts on the back of the panel. Just make sure you buy enough of them.
1
0
Report
A
Something small but nessecary
I never knew I even needed these until it came to designing a back panel for a rack unit. The holes have m3 threads on them, and are a lot easier to use than fiddling about with M3 nuts.
If you're creating a d-type rack panel, these are a must!
If you're creating a d-type rack panel, these are a must!
1
0
Report
d
A great help
Don’t by a d-norm socket without getting also this. No more fiddling with nuts. Just screw in your M3 bolts and you’re done. Only thing: buy one or two more than you need, just in case you strip a thread..
0
0
Report
R
Makes life a lot easier!
After struggling to fit nuts on the other side of the rack panel manually I have to say this little piece of kit is very handy if you plan to modify things often!
0
0
Report
TS
Perfect
Does the job!
One comment: when putting a couple of them right next to each other on a 16-holes rack they touch and bend a little. But the thing still holds perfectly fine
One comment: when putting a couple of them right next to each other on a 16-holes rack they touch and bend a little. But the thing still holds perfectly fine
0
0
Report
SC
I you need then, buy them.
They are good quality M3 threaded fixings for non-threaded XLR/Speakon/Powercon and other Chassis mount D-type connectors.
They clip onto the back of the connector, which makes them easy to mount because you don't have to hold them.
If you need them, why look else where? They are a fair price and they provide anti-rotation mounting for anything you put in it.
They clip onto the back of the connector, which makes them easy to mount because you don't have to hold them.
If you need them, why look else where? They are a fair price and they provide anti-rotation mounting for anything you put in it.
0
0
Report
L
Very usefull
Highly recommended to help mounting panels
0
0
Report
GP
good quality
very useful instead of trying to use a load of m3 bolts!
0
0
Report
M
I have used loads of these, perfect for rear mounting XLR and other D shape connectors with M3 screws.
0
0
Report
G
Much easier than screws and separate nuts
These make fixing the Neutrik D type connectors into panels much easier than trying to get the really small M3 nuts and screws into the correct position. A great timesaver when you have a lot of connectors to fasten into a panel.
0
0
Report