BB
Harley Benton musicial instruments and parts
I repair instruments, cheap and expensive, I love harley benton Parts, Use them all the time unless im working on a vintage or High end instrument, But I find I can use them on any instrument up to 1,000e.
1
0
Report
YK
Nice thumb bleeders
I had bought 3x4 thumb bleeders /knob pointers, along with a larger guitar package; however, I received just 4 numbers (perhaps lost in transit).
I'm satisfied with the product. This is an excellent alternative for anyone seeking high-quality products at a low cost.
I'm satisfied with the product. This is an excellent alternative for anyone seeking high-quality products at a low cost.
0
0
Report
R
Nice addition to your guitar
These look so good on some of my guitars. A few holes had to be enlarged for my bigger shaft pots, but it's easy to do with a sharp step drill bit
0
0
Report
GT
Unusable
Unusable, the middle hole is too small
0
0
Report
V
What a waste of money
Its one of these situations that you feel not only you wasted money but you have been scammed and trolled and got fooled for absolutely no reason at all.
I wanted to put these to my Gibson but their holes are 1mm or so , smaller. So i have 12 uselled markers...
What could go wrong if they made the holes a tiny bit bigger? It would fit in ANY situation
but no, they dont care, they made it only for Chinese guitars.. they dont want this to fit in Gibsons
That are they thinking???
Congratulations Harley Benton, well thought out product!
1 star
I wanted to put these to my Gibson but their holes are 1mm or so , smaller. So i have 12 uselled markers...
What could go wrong if they made the holes a tiny bit bigger? It would fit in ANY situation
but no, they dont care, they made it only for Chinese guitars.. they dont want this to fit in Gibsons
That are they thinking???
Congratulations Harley Benton, well thought out product!
1 star
3
6
Report
M
Good quality but only work with smaller diameter pots
These are a really good value if you're using cheaper pots with the smaller, metric shafts. These will not fit on a vintage or modern CTS pot - the whole is simply too small to fit around the mounting shaft.
0
0
Report
M
Okay for what it is
It was a little too big for my knobs. But after tightening, they work okay
0
0
Report
P
Great and cheap markers that do the job!
0
0
Report
